Advertisement
Installation
Wiring the electric winch
This winch can be used with temporary or permanent wiring.
Temporary wiring:
1. Lift the rubber seal of the socket at the right side of the winch housing and plug the cable in.
Lay the cable from the winch to battery making sure that it cannot be tangled in portable equip-
ment and cause a tripping hazard.
2. Connect the black clamp handle of the power cable with the frame of the vehicle, establishing
an earth connection. Connect the red clamp handle to the positive (+/red) terminal of the battery.
Note:
Make sure to use a 12 V car battery or equivalent in good condition.
3. Lift the rubber seal at the left side of the winch housing. Taking the remote-control unit, insert
the plug at the end of the cable into the socket on the right side of the winch housing labelled
"Remote control."
4. Lay down the remote control at a safe spot until the winch is ready for operation.
Permanent wiring:
1. Attach the over-current protection to the positive (+/red) terminal of your battery, using the bat-
tery terminal clamp bolt.
2. Choose a route for the cable from the place of your vehicle where the winch is to be mounted
to or where it is connected to the battery. This route must be safe, out of the range of moving
parts and road debris, and must not present any danger for the cable being damaged during
vehicle operation or maintenance. For example, the cables can be laid under the vehicle and
be attached by appropriate means to its frame. Nevertheless, do not attach it to the exhaust
system, drive shaft, emergency brake cable, fuel line, or any other components which may cre-
ate damage to the wiring through heat or motion, or create a fire hazard.
3. If drilling through the bumper or any part of the body to route the cables, be sure to install a
rubber grommet in the hole to prevent fraying of the wires at that point.
4. Now lay the power cable from the point where the winch will be used to the battery. Follow the
precautions discussed above.
5. Remove the red clamp handle and attach the red cable to the over-current protector mounted
to the positive (+/red) terminal of the battery.
6. Remove the black clamp handle and attach the black cable to the frame of the vehicle to create
a secure earthing.
Warning!
•
Always connect red to red (positive to positive) and black to the vehicle frame and create an
earthing if using the car battery.
•
Never use the winch or other accessories up to the point of total exhaustion of the battery. This
could permanently damage the battery!
•
You may keep the engine of the vehicle running while using the winch to continually recharge
the battery. However, be extremely cautious when working on a vehicle the engine of which is
running.
•
Do not use any dirty, corroded, or leaking battery. The acid can burn your skin, causing an
injury.
•
Always wear approved eye protection when working on or with a battery.
Mounting the winch
This winch is designed to be mounted temporarily to trailer hitch mounting bracket. Nevertheless, it can
be mounted permanently, too.
Permanent mounting:
1. Select a mounting spot at the bumper of your vehicle, truck bed, boat trailer, or other suitable
location. Note: The winch can generate 907 kg (2000 lbs) pulling force. Make sure that the spot
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61000–61002, 61769
Page 6
10
2021-1
Advertisement
