Electrical Connection Diagram; Installation Diagram - Crown FX 1560X User Manual

ELECTRICAL CONNECTION DIAGRAM

Section 4
Digital Touch Button

INSTALLATION DIAGRAM

Section 5
1. Draw a straight line by a measuring stick starting from the surface of the hob to 700+280: 990 mm if
you want to save a space of 700 mm between the hob and the lower surface of the chimney hood.
Align the drawn line to the right and left edges. Draw a 67,5 mm axis line from aligned center to every
sides. Make a hole by 6 mm diameter electrical drill through two drawn points. Penetrate the expansion
bolt and install the hangers.
2. Doing installation of secondary chimney of the chimney hood: draw 75 mm line from the top surface
towards the lower section. Make sure that the line is equal to right and left parts. Draw 50 mm line
each at both sides of the line and, then, make a hole through these two lines. Penetrate an 8 mm
diameter expansion bolt and tighten until 2 mm space is left in-between of a 2,5 mm diameter slat
screw and the expansion bolt. Later, the product is mounted on its place and the installation will be
completed by installing the inner chimney.
The operation order:
st
1 operation:
nd
2 operation:
Note: All dimensions are in mm.
Installation of hanger
Installation of chimney connection metal sheet
3