CommScope CAP MX Series Installation Manual page 48

Installing CAP MXs
14 Use both handles, and/or the provided lifting eye, on the CAP MX-2 chassis to lift it above the Mounting
Bracket with the back of its chassis facing the back of CAP MX-1, and lower it into place, allowing the M6
pins to rest in the slots of the mounting bracket as shown below.
15 On the right side of the CAP MX-2, secure the CAP MX to the Mounting Bracket by torquing the M6 nut to
11 N-m (100 in-lbs).
16 Repeat Step 15
CommScope ERA ® CAP MX Medium Power Carrier Access Point Installation Guide
Page 44
on the left side of the CAP MX.
Lifting eye
Allow M6 pins to
rest in mounting
bracket slots
M0203A5A_uc
© November 2020 CommScope, Inc.