Table of Contents
Advertisement
Left edge wider / right
edge narrower
(rotate clockwise)
If the projected image is distorted as above illustrations,
rotate the projector to correct it.
If the image is not clear enough, please use focus+ / - buttons
on the remote controller to adjust it.
(Note: Clockwise adjustment to the adjusters is to raise the height;
counterclockwise adjustment to the adjusters is to lower the height.)
left e dge narrower /
right e dge wider
(rotate counterclockwise)
(raise the tilt adjuster)
If the projected image is tilted as above
illustrations, adjust the tilt adjuster of
the projector to correct it.
When the "tilt adjuster" is adjusted to the
limit but the projection image is still tilted
as shown above, please further adjust
the left/right height adjusters
simultaneously in the same degree until
the "Normal" image is displayed.
(You may use the keystone function in the
system to do minor corrections.)
(raise the left height adjuster)
If the projected image is slanted as above
illustrations, raise or lower the right height
adjuster.
When the "right height adjuster" is raised
to the limit but the projected image is still
slanted to right, please lower the " left
height adjuster" until the "Normal" image
is displayed.
When the "right height adjuster" is lowered
to the limit but the projected image is still
slanted to left, please raise the "left
height adjuster" until the "Normal" image
is displayed.
(lower the tilt adjuster)
(tilt adjuster)
(lower the left height adjuster)
(Note: If not necessary, try not to
adjust the left height adjuster.)
(left height
(right height
adjuster)
adjuster)
Advertisement
Table of Contents
