7 PREPARING YOUR DEVICE
Remove the battery compartment cover.
Pull off the isolation strip to allow the
battery to make electrical contact.
Reinstall battery cover.
NOTE: Ensure the battery polarity (+/-)
matches the battery compartment sign.
6
8.0 PAIRING YOUR DEVICE
Open the GRID CONNECT App. Tap
device
around the push button is flashing
red, one flash per second before
tapping 'ready to pair' to proceed.
If the status light is not flashing
red, press the push button once
to activate the video doorbell then
press and hold the reset button
from the bottom of the video
doorbell for 5 seconds until a
prompt is heard. After 10 seconds,
the status light will start flashing red.
Tap 'ready to pair' to proceed.
security
, then select
on the
page. Confirm the status light
add
7