Ice And Water Dispenser - GE GSCS3KGYSS Owner's Manual & Installation Instructions

About the ice and water dispenser.
Spill Shelf
14
To Use the Dispenser
Select CUBED ICE
, CRUSHED ICE
or WATER
.
Press the glass gently against the top
of the dispenser cradle.
The spill shelf is not self-draining.
To reduce water spotting, the shelf
and its grille should be cleaned regularly.
If no water is dispensed when the
refrigerator is first installed, there may be
air in the water line system. Press the
dispenser arm for at least two minutes to
remove trapped air from the water line and
to fill the water system. To flush out
impurities in the water line, throw away the
first six glassfuls of water.
CAUTION: Never put fingers or any other
objects into the ice crusher discharge
opening.
Locking the Dispenser
Press the LOCK pad
for 3 seconds to lock
the dispenser and control
panel.
To unlock, press
and hold the pad
again for 3 seconds.
Important Facts About Your Dispenser
Do not add ice from trays or bags to
the storage drawer. It may not crush or
dispense well.
Avoid overfilling glass with ice and use
of narrow glasses. Backed-up ice can jam
the chute or cause the door in the chute to
freeze shut. If ice is blocking the chute,
poke it through with a wooden spoon.
Beverages and foods should not be
quick-chilled in the ice storage drawer.
Cans, bottles or food packages in the
storage drawer may cause the icemaker
or auger to jam.
To keep dispensed ice from missing
the glass, put the glass close to, but not
touching, the dispenser opening.
(on some models)
Dispenser Light
Some crushed ice may be dispensed even
though you selected CUBED ICE. This
happens occasionally when a few cubes
accidentally get directed to the crusher.
After crushed ice is dispensed, some water
may drip from the chute.
Sometimes a small mound of snow will
form on the door in the ice chute. This
condition is normal and usually occurs
when you have dispensed crushed ice
repeatedly. The snow will eventually
evaporate.
This pad turns the night light
in the dispenser on and off.
The light also comes on
when the dispenser cradle is
pressed. For models with a
bulb, if the light burns out, it
should be replaced with a 6
watt 12V maximum bulb.
For LED models, contact
Factory Service.
(on some models)
Quick Ice
When you need ice
in a hurry, press this
pad to speed up ice
production. This will increase
ice production for the
following
48 hours or until you press
the pad again.
(on some
Door Alarm
models)
To set the alarm,
press this pad until the
indicator light comes on.
This alarm will sound if
either door
is open for more than 3
minutes. The light goes out
and the beeping stops when
you close the door.