Replacing The Light Bulbs - GE GSCS3KGYSS Owner's Manual & Installation Instructions

Care and cleaning of the refrigerator.

Replacing the light bulbs.

Note: Turning the refrigerator off via the controls on the touch panel does not shut off electrical power to the
refrigerator.
Your light shield will look like
one of the following:
Tabs
OR
Pocket
16
Behind the Refrigerator
Be careful when moving the refrigerator away
from the wall. All types of floor coverings can
be damaged, particularly cushioned coverings
and those with embossed surfaces.
Pull the refrigerator straight out and return it to
position by pushing it straight in. Moving the
refrigerator in a side direction may result in
damage to the floor covering or refrigerator.
Preparing for Vacation
For long vacations or absences, remove food
and unplug the refrigerator. Clean
the interior with a baking soda solution
of one tablespoon (15 ml) of baking soda to
one quart (1 liter) of water. Leave the doors
open.
Set the icemaker power switch
to the OFF position and shut off
the water supply to the refrigerator.
Preparing to Move
Secure all loose items such as shelves and
drawers by taping them securely in place
to prevent damage.
When using a hand truck to move the
refrigerator, do not rest the front or back
of the refrigerator against the hand truck.
This could damage the refrigerator. Handle
only from the sides of the refrigerator.
(on some models)
Refrigerator Compartment—Upper Light
Unplug the refrigerator.
The bulbs are located at the top
of the compartment, inside the light
shield. On some models, a screw
at the front of the light shield will
have to be removed. On other models,
the screw is located in the pocket located
at the back of the shield.
To remove the light shield, on some
models, press in on the tabs on the sides
of the shield and slide forward and out.
On other models, just slide the shield
forward and out.
(cont.)
When pushing the refrigerator back, make
sure you don't roll over the power cord or
icemaker supply line (on some models).
If the temperature can drop below freezing,
have a qualified servicer drain
the water supply system (on some models)
to prevent serious property damage due
to flooding.
Be sure the refrigerator stays in an upright
position during moving.
After replacing the bulb with an appliance
bulb of the same or lower wattage,
replace the light shield and screw. When
replacing the light shield, make sure that
the tabs at the back
of the shield fit into the slots at
the back of the light shield housing.
Plug the refrigerator back in.
GEAppliances.com