DeWalt DCF809 Original Instructions Manual page 12

English
WARNING: Shock hazard. Do not allow any liquid to get
inside charger. Electric shock may result.
WARNING: We recommend the use of a residual current
device with a residual current rating of 30mA or less.
CAUTION: Burn hazard. To reduce the risk of injury,
charge only D WALT rechargeable batteries. Other types
e
of batteries may burst causing personal injury and
damage.
•
•
•
•
•
•
•
•
CAUTION: Children should be supervised to ensure
that they do not play with the appliance.
NOTICE: Under certain conditions, with the charger
plugged into the power supply, the exposed charging
contacts inside the charger can be shorted by foreign
material. Foreign materials of a conductive nature such
as, but not limited to, steel wool, aluminum foil or any
buildup of metallic particles should be kept away from
charger cavities. Always unplug the charger from the
power supply when there is no battery pack in the
cavity. Unplug charger before attempting to clean
8
•
t will not be stepped on, tripped over, or otherwise
subjected to damage or stress.
•
M Do not use an extension cord unless it is absolutely
a necessary. Use of improper extension cord could
result in risk of fire,electric shock, or electrocution. Do
k
not place any object on top of charger or place the
e
charger on a soft surface that might block the
s
ventilation slots and result in excessive internal
u
heat. Place the charger in a position away from any
r
heat source. The charger is ventilated through slots in
e
the top and the bottom of the housing.
t
Do not operate charger with damaged cord or
h
plug— have them replaced immediately.
a
Do not operate charger if it has received a sharp
t
blow, been dropped, or otherwise damaged in any
c
way. Take it to an authorised service centre.
o
Do not disassemble charger; take it to an authorised
r
service centre when service or repair is required.
d
Incorrect reassembly may result in a risk of electric
i
shock, electrocution or fire.
s
In case of damaged power supply cord the supply cord
l
must be replaced immediately by the manufacturer,
o
its service agent or similar qualified person to prevent
c
any hazard.
a
t Disconnect the charger from the outlet before
e attempting any cleaning. This will reduce the risk of
electric shock. Removing the battery pack will not
d
reduce this risk.
s
o
NEVER attempt to connect two chargers together.
t
The charger is designed to operate on standard
h
230V household electrical power. Do not attempt
a
to use it on any other voltage. This does not apply
t
to the vehicular charger.
i
• DO NOT attempt to charge the battery pack with
any chargers other than the ones in this manual.
The charger and battery pack are specifically
designed to work together.
• These chargers are not intended for any uses other
than charging D WALT rechargeable batteries. Any
e
other uses may result in risk of fire, electric shock or
electrocution.
• Do not expose charger to rain or snow.
Charging a Battery (Fig. B)
1. Plug the charger into an appropriate outlet before
inserting battery pack.