GE Spacemaker WSLS1100H Owner's Manual & Installation Instructions page 11

WASHER CONNECTIONS FOR STATIONARY MODEL
WSLS1100
WARNING:
FLUSH WATER LINES
1
Run some water from the hot and cold faucets to flush
the water lines and remove particles that might clog
the water valve screens.
CONNECT TO WATER LINES
2
Connect the inlet hose ends to the HOT and COLD
water faucets tightly by hand, then tighten another
turn with pliers. Turn the water on and check for leaks.
CAREFULLY MOVE THE WASHER
3
TO ITS FINAL LOCATION
Installation Instructions
Make sure the washer is unplugged.
CONNECT DRAIN HOSE
4
Form a U shape on the end of the drain hose with the
hose pointed toward the drain. Place the hose in a
laundry tub or stand pipe and secure it with a cable tie
(not included).
NOTE: If the drain hose is placed in a stand pipe
without forming a U shape, a siphoning action could
occur. There must be an air gap around the drain
hose. A snug hose fit can also cause a siphoning action.
2 ⁄
3
Cable Tie
PLUG THE POWER CORD INTO A
5
GROUNDED OUTLET
Insure proper ground
exists before use
Cable Tie
Laundry Tub
Cable Tie
Stand Pipe
11