Bosch Thermotechnik EU 2 D Manual page 17

– Set the switching time with the
knob (rf).
Note: Within a heating circuit
(ch 1/ch 2), the heating periods
must not overlap.
Change or delete
switching times.
– Release the
– Change other switching periods in
the same way if desired.
Example for two switching
periods (Channel 1):
°C
6
Deleting unused switching
periods:
– Press and hold the
the switching period that is to be
deleted.
– Turn the knob (rf) to the left until
the display shows four lines
(Fig. 13).
– Release the
– Repeat the process for the
ton (re) located directly below.
Completing the setting:
– Press and hold the ∆ button (ri).
– Set the arrow with the knob (rf)
to the current day.
overlapping
button (re).
12 18 24
button (rd) of
button (rd).
but-
In Combination with the
TA 213 A/A1 (and NTC Storage):
– Set channel 1 of the timer to heat-
ing from 00.00 to 23.59 hrs.
Channel 1 is in operation during
the heating time of both channels
of the TA 213 A/A1.
3.3.5 Setting the Daily Program
The daily program sets switching pe-
riods for single days (e.g., the week-
end) that deviate from the weekly
program. Unused switching peri-
ods must be deleted!
Note: After the entry of a daily pro-
gram, the weekly program can no
longer be changed.
All programs must then be deleted
(clear button CL) and the switching
t
timer reprogrammed.
– Press and hold the ∆ button (ri).
– Set the arrow
to the desired weekday (e. g., 7. =
Sunday).
– Press and hold the
the switching period that is to be
changed.
The switching time of the weekly
program is displayed.
– Set the switching time with the
knob (rf).
– Release the
– Press and hold the
located directly below.
The switching time of the weekly
program is displayed.
– Set the switching time with the
knob (rf).
EU 2 D
with the knob (rf)
button (rd) of
button (rd).
button (re)
17