Makita CJ105D Instruction Manual page 12

FUNCTIONAL DESCRIPTION
Power button
To turn on the jacket or vest, connect all the cables,
press the power button on the battery holder, and then
press and hold the power button on the jacket or vest
for a few seconds. To turn off, press and hold the power
button on the jacket or vest.
NOTE: The power level indicator on the battery
holder is not used with the jacket or vest. Only the
power level indicator 4 will light up when using the
jacket or vest.
► Fig.11: 1. Power level indicator
NOTE: The battery holder automatically turns off
approximately 1 hour after the jacket or vest is turned
off.
Temperature adjustment
CAUTION:
For continuous operation, set the
temperature setting to "low" (blue). If the jacket or
vest is overheated, the jacket or vest may cause a
malfunction and cause an injury.
There are three temperature settings (high, medium, low).
When you switch on the jacket or vest, the temperature is
set to "high". Each time you press the power button, the
temperature setting changes as shown in the figure. The
color of the power button shows the current setting.
► Fig.12: 1. Red: "high" 2. White: "medium" 3. Blue: "low"
Indicating the remaining battery capacity
Only for battery cartridges with the indicator
► Fig.13: 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Lighted Off
(For 14.4 V and 18 V batteries only)
(For 14.4 V and 18 V batteries only)
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Battery protection system
The device is equipped with a battery protection sys-
tem. This system automatically cuts off power to the
heating parts to extend battery life. If the remaining
battery capacity is too low, the device will not operate.
When you turn the device on, the power is supplied to
the heating parts again, but stops soon. In this situation,
remove and recharge the battery cartridge.
Connecting USB devices
CAUTION:
Connect only devices that are
compatible with the USB power supply port. Not
doing so may cause a malfunction of the battery
holder.
NOTICE:
Before connecting a USB device,
always back up the data on the USB device. Not
doing so may cause a loss of your data.
NOTICE:
The battery holder may not supply
power to some USB devices.
NOTICE:
When not using or after charging,
remove the USB cable and close the cover.
NOTE: The actual output current varies depending on
the USB device to be connected.
NOTE: Battery power is consumed while the power
button is turned on. Always turn off the switch when
not in use.
NOTE: When charging multiple USB devices in suc-
cession, wait about 10 seconds after charging of the
previous device has completed before beginning to
charge the next device.
The battery holder (with the battery cartridge) can work
as an external power supply for USB devices.
1.
Open the cover and connect a USB cable (not
included) to the USB port. Then connect the other end
of the cable to the device.
2. Start charging:
When using battery holder (with the battery), press and
hold the power button until the power level indicator
lights up. The battery supplies DC 5 V, 2.4 A.
Battery holder (with battery)
► Fig.14: 1. Cover 2. USB port
The USB cable can be placed inside the jacket or vest
for convenience using the hole in the pocket and the
cable holder.
For CJ105D / DCJ205 / CJ106D / DCJ206
► Fig.15: 1. USB cable
For CV102D / DCV202
► Fig.16: 1. USB cable
12 ENGLISH