Advertisement
05
Assembling Your System
Once you've identified the best location for your antenna(s), it's time to set up a provisional
install. Keep your antenna(s) outside in the location you've selected, but run the cables and test
your router/hotspot indoors.
Don't drill any holes in your walls yet! Start with a temporary install to make sure everything is
working well, as described in the next section of the manual.
If you purchased the complete kit with your MIMO antenna(s), follow the steps below to
assemble and install your MIMO Antenna kit. If you just purchased the antenna, your assembly
may look a little different.
Getting the Complete Kit Set Up
Refer to the diagram to the right as needed, for assembling the complete kit.
1
Secure your MIMO Panel Antenna or Log Periodic Antennas to your mount if you
haven't already. If your kit includes the 2x Log Periodic Antennas, be sure to cross-
polarize them at ±45° from vertical (90° to each other). See section 2 above for more
information.
2
Mount the antenna(s) outdoors in the location and direction where you found the fastest
data rates using the method described in section 3.
3
Connect your MIMO Panel Antenna or Log Periodic Antennas directly to the coax cables
(RS400 if you purchased the complete kit).
4
Connect the two coax cables to the adapters and hand-tighten them.
5
Connect the two adapters to your cellular router or hotspot.
10
Advertisement
