GE Profile J2B918 Installation & Owner's Instructions page 52

Installation of the range.
Install the Anti-Tip Device
An Anti-Tip bracket is supplied with
instructions for installation in a variety
of locations. The instructions include
all necessary information to complete the
installation. Read the Safety Instructions
and the instructions that fit your situation
before beginning installation.
Typical installation of anti-tip bracket attachment to wall.
When All Hookups Are Completed:
MAKE SURE ALL CONTROLS ARE LEFT IN THE
OFF POSITION.
Converting to LP Gas
This range leaves the factory set for use with natural gas.
If you want to convert to LP gas, the conversion must be
performed by a qualified LP gas installer.
52
Wall plate
Bracket
Screw must
enter wood
or metal
(or converting back to natural gas from LP)
WARNING:
s
Range must be secured by Anti-Tip bracket
supplied.
s
If the Anti-Tip device supplied with the range
does not fit this application, use the universal
Anti-Tip device WB2X7909.
s
See instructions to install (supplied with
bracket).
s
Unless properly installed, the range could
be tipped by stepping or sitting on the door.
Injury might result from spilled hot liquids
or from the range itself.
MAKE SURE THE FLOW OF COMBUSTION
AND VENTILATION AIR TO THE RANGE IS
UNOBSTRUCTED.
The conversion instructions and LP orifices can
be found attached to the range next to the
pressure regulator.
Keep these instructions and the orifices in case
you want to convert back to natural gas.