Advertisement
Table of Contents
Carbatec Pen Assembly Press
CT-PAP1
GETTING READY
If you have the space on your workbench to
permanently mount your pen press, screw
it down to the bench top using the provided
countersunk holes.
(Fig. 01)
If you only require temporary mounting, you
can clamp it down to the bench top.
Alternatively, clamp it up right in a bench vise.
It is important to have the pen press fastened
and secured to prevent damage to your
workpiece.
It is recommended to attach anti-scratch pads
on the face of the metal jaw to protect your pen
parts during assembly.
The pen press is designed to assist pressing a
wide range of pen styles and fits most pen kits.
Please refer to the specific instructions of your
pen kit for details.
E
info@carbatec.com.au AU 1800 658 111 NZ 0800 444 329
128 Ingleston Road, Wakerley, Queensland Australia 4154
Fig. 01
(Fig. 02)
Fig. 02
C A RBATE C.C OM.AU
C a r bat ec P t y L td
ABN 84 010 706 242
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Carbatec CT-PAP1
Summary of Contents for Carbatec CT-PAP1
- Page 1 Carbatec Pen Assembly Press CT-PAP1 INSTRUCTIONS C a r bat ec P t y L td info@carbatec.com.au AU 1800 658 111 NZ 0800 444 329 128 Ingleston Road, Wakerley, Queensland Australia 4154 ABN 84 010 706 242 GETTING READY If you have the space on your workbench to Fig.
- Page 2 CT-PAP1 INSTRUCTIONS Fig. 03 Position the assembly lever in a vertical position. Place the pen part against the rear jaw. Align your pen tube / finished barrel with the pen part you wish to press together. (Fig. 03) Slide the movable rod towards the front jaw until the pen parts are close.
Need help?
Do you have a question about the CT-PAP1 and is the answer not in the manual?
Questions and answers