Advertisement
preparation before operation
AUTO RESTART FUNCTION
This unit has AUTO RESTART FUNCTION, but when
it is leaving factory, this function is set off. If you need
this AUTO RESTART FUNCTION, please contact with
the Service Center. Because the configuration of the
unit should be changed.
AUTO RESTART FUNCTION is ......
The operation mode, set temperature and fan speed will be memorized
when using the remote controller to control the indoor unit. If a power
failure occurs during operation, the AUTO RESTART FUNCTION may start
the unit automatically and run it at the mode set by the remote controller
before the power is off .
INDOOR UNIT
Turn the breaker on.
!
WARNING
Remove dirt from the power plug and insert it securely.
If dirt adheres to the plug or insertion is incomplete, it may cause a fire
or electric shock.
REMOTE CONTROLLER
1
Remove the front lid and insert batteries, and
then reattach the front lid.
Do not confuse(+)
and (-).
2
Press the RESET button.
Press it using a thin stick.
If the RESET button is not pressed, the remote controller
may not opetate correctly.
3
Press the TIME SET button
Press it using a thin stick.
Press the HOUR button and MINUTE button
4
(TIME SET button) to set the current time.
Each time the HOUR button is pressed, the time increases
one hour.
Each time the MINUTE button is pressed, the time
increases one minute.
5
Press the TIME SET button again and close
the front lid.
32
Insert the
cathode of the
batteries in the
first.
Advertisement
