Holmatro GRA4321 Manual page 37

Description
Battery pack BPA283 28 V - 3 Ah
Battery pack BPA284 28 V - 4.1 Ah
Battery charger BCH1 220 - 240 V, 50/60 Hz
Battery charger BCH2 100 - 120 V, 50/60 Hz
Mains connector BMC 1 220 - 240 V, 50/60
Hz - 28 V
Mains connector BMC 2 100 - 120 V, 50/60
Hz - 28 V
Carrying belt
Battery pack pouch
Pushing set in trunk
This pushing set contains the following items:
Set pulling head
Connection piece
Extension pipe - 165 mm
Extension pipe - 330 mm
Extension pipe - 600 mm
Pulling set in trunk
This pulling set contains the following item:
Swivel head
Rim adapter
RAM support HRS 22
RAM support HRS 22 NCT
3.8 Ram head
Two ram heads are delivered by default with every ram jack. Extra ram heads can be ordered if desired.
3.9 Ram support
The ram support is an accessory used for bodywork in an unstable condition. It provides a safe push-off
point to prevent slipping. The ram support has three push-off points and can be used in combination
with every ram jack. The push-off points are recognizable as round bars on which the ram head can be
placed.
3.10 Conical tip
The conical tip has a sharp point and can be used to make a hole in a plate. It can be placed on the end
of the plunger and/or fixed side, instead of the ram head.
3.11 Rim adapter set
The Holmatro rim adapter set consists of:
• a storage/carrying case
GRA4321 / GRA4331
• ram head
• wedge piece
• conical tip
• base plate
• set pulling chains
916.001.324_000
GRA4321 GRA4331
150.005.823
150.005.214
150.182.208
150.182.209
150.182.206
150.182.207
150.182.249
150.182.214
150.582.008
150.033.032
150.181.324
150.181.325
150.181.326
150.582.281
150.181.327
150.181.321
150.181.322
150.006.204
150.582.021
150.582.152
150.182.047
150.182.580
150.181.011
150.003.105
EN
37