Saving These Settings To Memory; Verify The Programming - Icom IC-2730A Programming Manual

Saving these settings to Memory

Your display should show your frequency, the duplex (DUP+ or DUP-), and the T for tone encoder. To
save these settings to a Memory Channel, do the following:
1. Press the [MW] key.
2. MW will blink on the display.
3. Rotate your dial to display CH SEL (channel selection).
4. Press the Enter key.
5. Rotate the dial to the memory channel you wish to use.
6. Press the Enter key.
7. Rotate the dial to WRITE.
8. Press the Enter key.
9. The display will show WRITE.
10. Rotate the dial to YES.
11. Press the Enter key.

Verify the Programming

To check the memory channels, momentarily press the [MR/CALL] key and rotate the dial through the
memory channels and confirm that the repeater is programmed into the memory channel that you
selected.
©June 2016 Icom America Inc.
Page 2
Icom America, Inc.
12421 Willows Road NE
Kirkland, WA 98034