Removing Propeller; Installing Propeller - Yamaha F6A Owner's Manual

Maintenance
Check each of the propeller blades for
G
wear, erosion from cavitation or ventilation,
or other damage.
Check the propeller shaft for damage.
G
Check the splines for wear or damage.
G
Check for fish line tangled around the pro-
G
peller shaft.
Check the propeller shaft oil seal for dam-
G
age.
EMU30661

Removing propeller

EMU29196
Spline models
1. Straighten the cotter pin and pull it out us-
ing a pair of pliers.
2. Remove the propeller nut, washer, and
spacer (if equipped).
1. Cotter pin
2. Propeller nut
3. Washer
4. Propeller
5. Thrust washer
64
1. Cotter pin
2. Propeller nut
3. Washer
4. Spacer
5. Propeller
6. Thrust washer
3. Remove the
equipped), and thrust washer.
EMU30671

Installing propeller

EMU29232
Spline models
ECM00340
CAUTION:
Be sure to install the thrust washer be-
G
fore installing the propeller, otherwise
the lower case and propeller boss could
be damaged.
Be sure to use a new cotter pin and bend
G
the ends over securely. Otherwise the
propeller could come off during opera-
tion and be lost.
1. Apply Yamaha marine grease or a corro-
sion resistant grease to the propeller
shaft.
2. Install the spacer (if equipped), thrust
washer, washer (if equipped), and pro-
peller on the propeller shaft.
3. Install the spacer (if equipped) and the
washer. Tighten the propeller nut to the
specified torque.
propeller, washer (if