Related Manuals for Walker Edison W60C73BL
Summary of Contents for Walker Edison W60C73BL
- Page 1 W60C73BL, W60C73MB, W60C73CH ASSEMBLY INSTRUCTIONS For our most up-to-date instructions, to request missing, lost, or broken parts, or for any other Customer Service issues, please visit our website at www.walkeredison.com or call us at 877-207-5906.
-
Page 2: General Assembly Guidelines
General Assembly Guidelines I. Ensure that all parts are available before beginning assembly. II. Follow each step carefully to ensure proper assembly of this product. III. The four main types of hardware used to construct this TV console are: wood dowels, cam and bolt, hex-head bolts, and screws. - Page 3 W60C73BL, W60C73MB, W60C73CH Parts List...
- Page 4 * The hardware quantities listed are required for proper assembly. Some extra hardware may have also been included.
- Page 5 Assemble door frames using dowels (C) and cam bolts (B). Build door faces by attaching cam bolts (B) and fastening plates (J). Tighten cam locks (A) using a screwdriver as shown in the diagram. Attach door handles (N) to the front of doors.
- Page 6 Insert dowels (C) into door faces. Attach the door faces to the door frames. Assemble the center shelf frame section by inserting dowels (C) Tighten cam locks (A) using a screw driver as shown. Set door assembly aside for later use. and attaching the pieces as shown in the diagram.
- Page 7 Finished sides face out Assemble and attach the side shelf frames to the center frame section using dowels (C), cam locks (A) and cam bolts (B). Tighten cam locks (A) using a screwdriver as shown in the diagram.
- Page 8 Insert dowels (C) and cam locks (A) into the stand top. Attach the frame to the stand top (2 people recommended). Attach cam bolts (B) and door stops (G) to the stand top as shown. Tighten cam locks (A) using a screwdriver as shown in diagram.
- Page 9 Attach the base to the frame assembly with hex screws (E). Slide the back panel sections (10 & 11) into the stand frame. Tighten using the provided hex wrench (F).
- Page 10 Insert dowels (C) into stand base. Attach corner legs (S) to dowels. Attach middle legs (Q) Attach the hinges (L) to the assembled doors using screws (M). into predrilled starter holes with screws (R). Tighten with a screwdriver.
- Page 11 Attach the door hinges to the stand frame using screws (M). Align edge of hinges with edge of frame. Tighten with a screwdriver. You may need to loosen screws, adjust placement of hinges and re-tighten for proper alignment of doors on frame.
- Page 12 Small plastic wedges (R) are optional and can be used to tighten the fit of the Insert shelf support pins (I) to frame at desired height and carefully back panels against the framework. Secure wedges to back panels using screw (S). place shelves as shown in the diagram.