Advertisement
A
STEP
Startup Checklist
Digital Outputs
Verify digital output operation
□
The S15 has three outputs available; two relay outputs and one digital output. Two of the outputs can have
more than one function assigned. Parameter
change state or only one function is required. Refer to Section 11.7 of the S15 Instruction Manual E6582175
for more details.
Function
Parameters
Assigned Function
Function
Parameters
Assigned Function
Function
Parameters
Assigned Function
Analog Outputs – Refer to S15 App Note 1.4.0 Analog Output Calibration for calibration procedure and
parameters.
Verify analog output operation
□
Terminal
FM
© Toshiba International Corporation 2021 www.toshiba.com/tic Email: TIC-ASD@toshiba.com (855) 803-7089 13131 West Little York Road, Houston, TX
Terminals FLA/FLB/FLC
(Default - Fault Status)
f132
10: Fault Status
(Default - Run Status)
f130
4: Low-Speed Detection Signal
(Default - Speed Reach)
f131
6: Speed Reach
Function
Parameter
fmsl
Output Frequency
f139
determines if both functions are required to be true to
Terminals RY/RC
255: Always ON
Terminals OUT/NO
255: Always ON
Default
0: Output Frequency
N/A
f137
f138
New Function Assigned
Advertisement
