Basic Disassembly - Agilent Technologies 34980A Service Manual

Basic Disassembly

Observe the electrostatic discharge precautions given on
1
2
3
34980A Service Guide
Remove the power cable from the unit. If attached, remove the analog bus connector.
If desired, you may also remove the feet by lifting the tab on each foot and sliding
a
the foot toward the rear of the instrument.
Remove all plug-in modules.
Using a T-20 Torx driver, loosen the five captive screws in the rear bezel and remove
the bezel. The metal cover will now slide off.
Disassembly and Repair
page 116.
5
117