Tools Needed For Assembly; Assembly And Adjustments - KNOVA KN DP-2000N Manual

TOOLS NEEDED FOR ASSEMBLY

SUPPLIED
3 mm hex key
4 mm hex key

ASSEMBLY AND ADJUSTMENTS

WARNING
• For your own safety, never connect plug to power
source outlet until all assembly steps are complete
and you have read and understood the safety and
operating instructions.
• The drill press is a heavy power tool and should be
lifted with the help of two PEOPLE OR MORE to
safely assemble it.
ASSEMBLING COLUMN TO BASE (FIG. A)
• Position the base (1) on a flat work surface.
• Place the column assembly (2)
on the base (1), aligning
the three mounting holes
to the base.
• Locate the three hex bolts (3)
from the loose parts bag.
• Place a bolt in each hole through
the column support and thread
into the base. Tighten with
a 13 mm wrench.
ASSEMBLY (FIG. B)
• Install the table lock
handle (3) in the threaded
hole (4) located in the back
of the table assembly (1).
• Slide the table assembly (1) down along the column
assembly (2) to desired working height, and tighten
the table lock
handle (3) to
secure the table
in place.
NOT SUPPLIED
Phillips screwdriver
Slotted screwdriver
10, 13 & 16 mm wrench
2
1
1
NOT SUPPLIED
Adjustable wrench
Combination square
INSTALLING THE HEAD (FIG. C)
WARNING
The drill press head is heavy and should be lifted with
the help of two PEOPLE to safely assemble the drill
press head on the column.
• Carefully lift the head (1) above the column assembly (2)
and slide it down the column as far as it will go.
• Align the head (1) with the base.
• Tighten the two head
locking screws (3)
with a 4 mm
Fig. A
hex key.
3
INSTALLING FEED HANDLES (FIG. D)
• Screw the three feed handles (1) into the holes (2)
on the hub assembly (3) and tighten.
4
3
2
Fig. B
8
1
Fig. C
Fig. D
2
NOT SUPPLIED
Block of wood
Hammer or
rubber mallet
3
2
1
3