Operation - Emerson Stinger WD2020 Owner's Manual

SP6924 2 GALLON Stinger ESF.qxp_SP6568-2 Stinger.qxd 6/6/14 2:43 PM Page 7

Operation

WARNING: To reduce the risk of fire, explosion, or damage to Vac:
• Do not leave Vac running while unattended - you may fail to notice important
signs indicating abnormal operation such as loss of suction, debris/liquid
exiting the exhaust, or abnormal motor noises. Immediately stop using Vac if
you notice these signs.
• Do not leave Vac plugged in when not in use.
• Do not continue running when float has cut off suction.
• Sparks inside the motor can ignite airborne flammables. Do not operate Vac
near flammable liquids or in areas with flammable gases, vapors, or
explosive/airborne dust. Flammable liquids, gases, and vapors include:
lighter fluid, solvent-type cleaners, oil-based paints, gasoline, alcohol, and
aerosol sprays. Explosive dusts include: coal, magnesium, aluminum, grain,
and gun powder.
• Do not vacuum up explosive dusts, flammable liquids, or hot ashes.
• Do not expose to rain or allow liquid to enter motor compartment.
Store indoors.
• Do not handle plug, switch, or Vac with wet hands.
• Unplug Vac before servicing. If your Vac is not working as it should, has
missing parts, has been dropped, damaged, left outdoors, or dropped into
water, return it to an independent service center or call customer service.
• When using an extension cord, use only outdoor-rated cords that are in good
condition. Do not allow the connection to come into contact with liquid.
Your two-gallon Wet/Dry Vac is assembled
at the factory and ready for use when you
remove it from the carton. The unit is ready
for dry vacuuming or blowing.
After you plug the power cord into the
switch from position "O" to position "I".
outlet, turn the unit on by pushing the
The symbols used on the switch are
international symbols.
= OFF
WARNING: To reduce the risk of electric shock or injury:
= ON
"I" - "ON"
Position
7
"O" - "OFF"
Position