Hitachi 46W500 Training page 87

DP-3X HORIZONTAL SIZE ADJUSTMENT
HORIZONTAL SIZE:
(Display Mode NORMAL)
•
Install the correct Overlay.
•
Input an NTSC Signal.
•
Digital Convergence RAM
should be cleared. With
Power Off, press the Service
Only switch on the Conver-
gence PWB. While holding
the Service Only Switch
down, press the Power On
button and Release. DCU
Grid will appear without
convergence correction.
Screen Size
46 inch
51 inch
57 inch
65 inch
NOTE: After entering
DCAM, with each press of
the Service Only Switch, the
picture will toggle between
Video mode and DCU Grid.
•
Project only the Green
raster by selecting Green
Adjustment mode and press-
ing the MENU button on
remote.
ADJUSTMENT
1. Adjust using R711
(Horz. Size Adj. VR) Ad-
HORIZONTAL SIZE
Outside Left and Right
hand lines
DP37 DP37C/D/P
L=
- -
1020 mm
1140 mm 1140 mm
1300 mm 1300 mm
2) Press "Power Off" to exit
NOTE: Do not use the Hash
marks on the Overlay as they
may be incorrect and/or the
Vertical Size may change to
improve performance.
l l l l
DP36
L=
- -
- - 1005 mm
1120 mm
1280 mm
just Horizontal Size until
the size matches the chart
below.
DCAM. (Digital Conver-
gence Adjustment Mode.)
DP33W
L= L=
- - 930
- -
- -
- -
PAGE 07-03