Hitachi 46W500 Training page 85

DP-3X CHASSIS DCU CROSSHATCH PHASE ADJUSTMENT
Adjustment Preparation:
Cut Off adjustment should
•
be finished.
Video Control: Brightness
•
90%, Contrast Max.
Adjustment Procedure:
NORMAL MODE
1) Receive any NTSC signal.
2) Screen Format is Normal
3) Press the SERVICE
ONLY switch on the De-
flection / Convergence
PWB to enter DCAM.
4) Press the PHOTO key on
the Remote, Green Cross
hatch appears.
5) Then press the EXIT key.
(This is the Phase
ADJUST USING
4 and 6 keys on Remote
2 and 5 keys on Remote
Cursor Left and Right on Remote
Cursor Up and Down on Remote
adjustment mode).
6) Adjust data value using
the keys indicated in the
chart, until the data
matches the values indi-
cated in the chart.
Exiting Adjustment Mode:
7) Press PHOTO key on
remote control.
8) Press PIP MODE key
TWICE to store the
information.
9) When Green dots are
displayed, press the
MUTE key twice to re-
turn to DCAM grid.
PHASE MODE
*DCA stands for (Digital
Convergence Adjustment)
Display Format NORMAL
Address
Data Value
PH-H
PH-V
CR-H
CR-V
E2
07
35
14
PAGE 07-01