Operation - Frontier LS2011 Operator's Manual

Sprayer Setup
Filling Sprayer Tank
CAUTION: Chemicals can be
dangerous. Avoid injury to operator
or bystanders.
• Read chemical container label for mixing
and handling instructions. A Safety Data
Sheet (SDS) should be supplied by the
chemical dealer and provides proper safety
information.
• Wear proper clothing and safety equipment
while handling or applying spray chemicals.
• Wear a full covering of clothing, protective
goggles and rubber gloves.
• Prohibit all smoking, drinking, and eating
around chemicals.
• When filling tank, never allow end of water
hose to contact chemical mixture.
IMPORTANT: Avoid damage! Clean any spills
immediately with clean water prior to operating
sprayer.
1. Park machine safely. (See Park Machine
Safely in Safety section)
2. Lower tractor lift link so that the sprayer is
firmly on the ground.
3. Clean area around tank filler cap to prevent
tank contamination.
4. Remove tank filler cap and fill tank.
5. Install tank filler cap.
NOTE: The preferred location to fill the tank is
from the front left corner.
5CS201115OM (rev 00 07/2020)

OPERATION

Draining and Cleaning the Sprayer Tank
Dilute it with water and apply it to area
previously treated.
• Never dump excess into a storm drain or
near a lake or stream.
1. To quickly empty the tank of excess
material, turn 3-way valve (A) to drain
position as shown.
2. Spray all inside surfaces of tank with
low pressure garden hose to remove
any remaining solution. Rinse sprayer
tank, pump, sprayer wand and all hoses
thoroughly with fresh, clean water. Rinse
several times to make sure sprayer tank is
clean and free of chemicals.
3. When tank is empty, Allow tank to air dry.
4. Turn 3-way valve (A) to OFF position
(Vertical) and install filler cap.
IMPORTANT: Avoid damage!
• Clean any spills. Proper disposal
of excess spray is very important.
A
LS2011
LS2015
Operation
A
19