ReSound Smart Fit cable guide
Wireless and non-wireless
programming
ReSound ONE
™
ReSound LiNX Quattro
ReSound LiNX Quattro
ReSound ENZO Q
™
ReSound Key
™
Cable connection for non-wireless programming
CUSTOM MODELS
With the battery door ajar, insert the flex strip into the slot
beside the hinge pin. The black dot on the flex strip should
be facing away from the battery door. The flex strip is fully
inserted when the black dot abuts the hearing instrument
case. Close the battery door once the flex strip is inserted.
RIE: 61
Locate the programming slot below the push-button. Open the
battery door. With the black dot on the flex strip facing the push
button on the hearing instrument, insert the flex strip into the
slot and close the battery door.
MINI BTE: 67
Locate the programming slot below the microphone port.
With the black dot on the flex strip facing the push button on
the hearing instrument, insert the flex strip into the slot, until
the black dot abuts the hearing instrument case.
Truly wireless
fitting
(no cable
required)
Fresh battery
RIE
™
Custom, RIE, BTE
Rechargeable
™
RIE 61-DRWC
BTE
Custom, RIE,
BTE
3-pin CS53 flex strip and
4-pin CS44 socket cable
Fresh battery
-
Custom, RIE: 61,
Mini BTE: 67
-
-
Custom, RIE: 61,
Mini BTE: 67
RIE: 62 and BTE MODELS
To connect the programming adaptor, hold it at a 45° angle
and insert the small pins at the tip of the adaptor into the
square cut-out on the underside of the hearing instrument.
Once in place, move the adaptor in the direction of the
battery compartment and then gently click it into place.
5
BTE: 98
Remove the existing battery door and replace with the
DAI/battery door (19215000).
4
5
(original
(ENZO
adaptor)
adaptor)
ENZO
Programming
Adaptor II and
Programming
4-pin CS44
Adaptor
socket cable
19215000
Fresh battery
Fresh battery
-
-
RIE: 62, BTE
-
-
-
BTE: 88
BTE: 98
RIE: 62,
BTE: 98
BTE: 77, 88