Operation; Setting Combine Ids (Method 1) - Philips ILS-CL-8RES User Manual

Operation

Setting Combine IDs (Method 1)

Each of the 8/16 buttons can be programmed to combine two rooms
(or IDs) when the button's LED is turned On. To program the two
IDs into each button, do the following:
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
A
B
C
D
Step 1. Press and hold A and H buttons for 3
seconds (Mode 3 unit). After 3 seconds, all
eight buttons will start to blink.
Step 2. Press button to be programmed (switches
1-8) or press button (switches 9-16) on a
second unit set to Mode 1 or press button
(switches 9-16) on a third unit set to Mode
2. A will blink ONE time and then delay.
Step 3. Enter three MSBs (most significant bits) of
first ID on bottom three buttons (refer to
ID Values on next page).
Step 4. Press A. Top button will now blink TWO
times and then delay.
Step 5. Enter five LSBs (least significant bits) of
first ID on bottom five buttons (refer to ID
Values on next page).
Step 6. Press A. Top button will now blink
THREE times and then delay.
Room Combine Switch User's Guide
13