Obihai Obi300 Quick Start Manual page 2

Hide thumbs Also See for Obi300:

Ports on the Back of an ObiHai ATA

ObiHai devices shown – Obi300 and Obi302. Obi300 supports one analog line (1 port) and

Obi302 supports 2 analog lines (2 ports). A frequently asked question in regards to these devic-

es are where to plug the router into. When plugging in the device to your router, please ensure

you're plugging it into the port labeled "Internet".

Factory resetting an Obihai ATA

Using a paper clip, press and hold the pinhole button located on the back side of the ATA until

the power light changes from solid green to a blinking green. Release the button.

Star Codes on an Obihai ATA

When a device is showing a blinking green power light a deciding factor is to determine if your

phone is receiving an IP address and if it is, what that IP address is. If will also tell you if DHCP is

enabled. From the analog phone that is plugged into the ATAT dial *** then when prompted press

1. This will reach out back the IP address currently associated with the device is the status of the

DHCP (enabled vs. disabled).

When you are prompted by someone at Granite to reboot the ATA device from the analog phone,

dial *** then select 9 to reboot the device and 1 to confirm the reboot. The power light will go red,

then blink green, then if able to connect- solid green.

clienttraining@granitenet.com | 866.847.1500 |

ObiHai Obi300 and

Obi302 ATA's

Granite Telecommunications

Obi302