Names And Functions Of Parts - Canon IMAGEFORMULA DR-2010M Reference Manual

Names and Functions of Parts

This section describes the name and function of each part. Make sure
to read this section and familiarize yourself with the parts of the
scanner before using the scanner.
■ Front View/Right-Side View
Document Feed
Tray
Open to place
documents.
Document Eject Area
Scanned documents
are output here.
■ Front View (With the Document Feed Tray and Eject Tray Open)
Front Unit
Open when clearing paper
jams and cleaning the
scanner.
OPEN button
Use to open the
front unit.
Extension Tray
Pull this tray out if the document
hangs over the edge of the
document eject tray.
Job Buttons
These buttons can
perform user-
specified functions
assigned with the
CaptureOnTouch.
Power Indicator
This indicator lights
green when the
scanner is turned
ON.
Document Feeder
Place the document
to scan here.
Document Guides
Adjust these guides to
fit the width of the
document.
Document Eject Tray
Open this tray when you want
to stack output documents.
■ Back View
Power Switch
This switch is used to turn
the scanner ON and OFF. If
you set the switch to
[AUTO], the scanner is
linked to be automatically
turned ON/OFF in
accordance with the power
of the computer.
Power Connector
Connect the supplied AC
adapter to this connector.
■ Feed Selection Lever
■ Paper Eject Stopper
Paper Eject Stopper
Use the paper eject stopper
that corresponds to the
length of the documents you
want to scan.
8
USB Connector
Connect a USB cable that
supports Hi-Speed USB
2.0 to this connector.
Theft Prevention Hole
(Kensington)
Attach a key chain, etc.
here to prevent the
scanner from being
stolen.
Feed Selection Lever
Use this lever to change the way
documents are fed. Push it up to feed
documents one at a time (page
separation mode). Push it down to feed
documents that are fastened together,
such as invoices, without separating
them (bypass mode).