HELIOTERM INVERTER
CSD 35 - PLACA ELETRÓNICA PARA O
COMANDO NA PAREDE
Avisos preliminares
Estas instruções são parte integrante do manual do aparelho
no qual o KIT é instalado. Consulte este manual para as
ADVERTÊNCIAS GERAIS e REGRAS FUNDAMENTAIS DE SEGURANÇA.
Em algumas partes do manual são utilizados os símbolos:
ATENÇÃO = para ações que exigem cautela especial
e preparação adequada.
PROIBIDO
=
para
absolutamente ser executadas.
Versões
Códigos
20116411
CSD 35 - Placa eletrónica para o comando na parede
Montagem, configuração e ligações dos
painéis de comando a bordo da máquina
O comando possui contactos limpos independentes para
o comando de um refrigerador, de uma caldeira e de uma
entrada do contacto de presença. Se for uma versão de
2 tubos, está equipado com uma saída de 230 V para o
comando da eletroválvula de verão e inverno. Através da
sonda de temperatura da água de 10 kΩ posicionada na
cavidade presente na bateria, o aparelho pode gerir as
funções de temperatura mínima da água no aquecimento
(30 °C) e máxima no arrefecimento (20 °C). A placa prevê
também o funcionamento sem sonda H2, nesse caso, os
limites de paragem do ventilador são ignorados.
PT
ações
que
não
devem
CSD 35 - ELECTRONIC BOARD FOR WALL
CONTROL
Preliminary instructions
This instruction booklet is an integral part of the manual
of the device on which you install the kit. In that manual,
please refer to the WARNINGS and the BASIC SAFETY RULES.
The following symbols are used in this publication:
WARNING = actions requiring special care and
appropriate training.
DO NOT = actions that MUST ON NO ACCOUNT be
carried out.
Versions
Codes
20116411
CSD 35 - Electronic board for wall control
Mounting, setting and connection of on-
board machine control panels
The control have independent free contacts to control
a chiller and a boiler and a presence input. The 2-pipe
versions have a 230 V output for powering the summer
and winter solenoid valve while. The water temperature
probe (10KΩ) located in the well on the battery manages
the minimum in heating (30°C) and maximum in cooling
(20°C) functions.
The board can also operate without a water probe, case in
which the fan stop thresholds will be ignored.
1
EN
Doc-0091338 Rev. 0