Table of Contents
Advertisement
Water plus
You can determine the amount of
water used if the Water + extra is
selected.
Selection
= More water is used in the wash
and rinse stages (factory
default setting)
= An extra rinse is carried out
= The water level in the wash
and rinse stages is increased
and an extra rinse is carried
out
Water plus level
There are three different water levels
which can be selected by activating
the Water + extra.
Options
= No higher water level (factory
default setting)
= Water level increase by 1 level
when washing and rinsing
= Water level increase by 2 levels
when washing and rinsing
= Water level increase by 3 levels
when washing and rinsing
Programmable functions
Maximum rinse level
The water level in the rinse cycle can
be permanently set to the highest
value.
This function is useful for allergy
sufferers as it achieves an excellent
rinse result. Water consumption will
increase.
Options
= Maximum rinse level is
switched off (factory default
setting)
= Maximum rinse level is
switched on
Suds cooling
When this is activated, additional
water flows into the drum at the end of
the main wash to cool the suds down.
Hot suds can damage plastic drainage
pipes.
Suds cooling takes place when a
temperature of 70 °C or higher is
selected for the Cottons programme.
Suds cooling should be activated:
- to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
- where drainage pipes do not comply
with DIN 1986.
Options
= Suds cooling is switched off
(factory default setting)
= Suds cooling is switched on
75
Hide quick links:
Advertisement
Table of Contents
