Spinning - Miele WWD 120 Operating Instructions Manual

Spinning

Final spin speed in wash
programmes
When a programme is selected, the
sensor control for the optimum spin
speed for that programme will be
brightly lit up in the control field.
A faster spin speed can be selected for
certain wash programmes.
The highest selectable spin speed is
indicated in the table.
Programme
Cottons 
Cottons
Minimum iron
Delicates
Woollens 
Shirts
Express 20
Dark garments/Denim
ECO 40-60
Proofing
Drain/Spin
Separate rinse/Starch
Rinse and interim spin
There is a spin after the main wash and
between the rinses. A reduction in the
final spin speed will also reduce the
interim spin speed. If a spin speed of
less than 700 rpm is selected for the
Cottons programme, an additional rinse
is introduced.
28
Selecting Rinse hold (final spin)
 Touch the  sensor control (Rinse
hold).
The laundry is not spun after the final
rinse and remains in the rinse water.
This helps to prevent creasing if the
laundry is not going to be removed from
the drum immediately after the end of
the programme.
Ending a programme with a spin
cycle
rpm
The sensor control for the optimum spin
1400
speed lights up on the control field. You
1400
can change the spin speed.
1200
 Touch the Start/Add laundry sensor
900
control.
1200
Ending a programme without a spin
900
cycle
1200
 Reduce the spin speed to 0.
1200
 Touch the Start/Add laundry sensor
1400
control.
1200
To omit rinse and interim spin
1400
and the final spin
1200
 Touch the  sensor.
After the last rinse, the water will be
pumped away and the anti-crease
phase will switch in.
In some programmes an additional rinse
is introduced with this setting.