To Drill From Bottom; If Cabinet Has A Partition - GE Monogram ZEM200BF Installation Instructions Manual

– Position remaining piece of Template 2 inside
To drill
from inside
– Cut excess paper from center of Template 2 so
(continued)
– Distance from right hole center to left hole
– Tape remaining portion of Template 2 in
• With template secured in place, check again
• Position Template 2 flat against underside of
To drill from
bottom
If cabinet has partition:
If cabinet
has a
partition
cabinet and align hole center line with arrows
on Template 1.
it will lie flat.
center should measure distance indicated on
template.
place.
that hole center lines on Template 2 are
straight, and that distance from right to left
hole center measures distance shown on
template.
cabinet:
– If cabinet is less than 12" deep, cut that
amount off front edge of template.
– If cabinet has a front rail, cut front edge of
template to fit; place cut edge against back
of front rail.
– Cut template to fit around corner brackets
or glue blocks underneath cabinet.
– Cut Template 2 into two pieces to fit on
either side of partition.
– Align front edge of one template piece with
front edge of cabinet or back of front rail;
tape in place.
– Tape Template 1 to rear of cabinet,
aligning arrow with hole center line on
Template 2.
– Position remaining piece of Template 2
under cabinet and align hole center line
with arrows on Template 1.
– Cut excess paper from center of Template 2
so it will lie flat.
– Distance from right hole center to left hole
center should measure distance indicated
on template.
– Tape remaining portion of Template 2 in
place.
Installation
Microwave Oven
13