RedMax EBZ8560 Workshop Manual page 10

Item Description
1 Torx wrench
2 Socket key
3 Puller
4 Air gap gauge 0.3 mm
5 Piston stop
5-1 Piston stop male
6 Bearing guide
7 Piston pin tool
8 Pressure test plug
9 Needle cap removal tool
10 Ignition tester
11 Inlet seal
12 Fuel filter hook
13 Pressure tester
14 Compression tester
15 Crankcase support
16 Crankshaft installation tool
Crankshaft installation bolt
Crankshaft installation nut
10 - Servicing tools
Use to
Remove and install torx screws.
Remove and attach nuts.
Remove the rotor.
Install the ignition module.
Lock the piston when the crankshaft
nuts are removed.
Lock the piston when the crankshaft
nuts are removed.
Install bearing.
Remove piston pin.
Pressure test.
Remove carburetor needle cap.
Spark strength check.
To close exhaust port and inlet port.
To pull out the fuel filter from the tank.
To do a pressure test.
Do a compression test.
Support for the crankcase when bear-
ing is installed.
Install the crankcase.
Install the crankcase.
Install the crankcase.
Article number
578 28 90-01
502 50 23-01
577 40 97-01
516 88 03-01
529 80 24-01
529 80 26-01
577 40 98-01
521 53 35-01
579 18 69-01
521 53 38-01
501 97 64-01
502 54 11-02
502 50 83-01
531 03 06-23
577 26 27-01
577 41 01-01
582 04 35-01
582 04 36-01
510 53 09-01
1662 - 003 - 04.11.2021