Advertisement
Maintenance:
Maintenance of the B.A.T. and associated components consists of primarily c leaning, and
battery replacement. The glass protective lens on the laser e mit t e r is cleaned easily with a
soft cloth or swab with any glass cleaner. Cleaning of the targets is achieved with a damp
cloth; use no solvents or other c le a nin g solutions. Replacement target tape is available from
alignment supplies.
Calibration:
The B.A.T. Laser Emitters and all targets are calibrated in our production facility.
Calibration is recommended every t w o years. Or as your company policy requires.
Batteries:
Two "AAA" batteries are required to power the B.A.T. laser e mit t e r.
1. Remove the batteries by turning the battery nut clockwise and tipping ba tte ry port
down.
2. Remove batteries when not in use and during s to ra ge to prevent damage to the
tool. Damage from leaking or failed batteries is NOT covered under the warranty.
3. Install replacement batteries, Note: Use Alkaline batteries only! Typical battery life is
4 to 6 hours. Keep spare batteries in the B.A.T. carry case.
Toll Free: 800.997.4467|
11
alignmentsupplies.com
Advertisement
