Operating The Traction Drive; Operating The Speed Selector; Operating The Auger/Impeller Drive - Toro Power Max 39924 Operator's Manual

Operating the Traction
Drive
CAUTION
If the traction drive is not properly adjusted,
the machine may move in the direction
opposite of what you intended, causing injury
and/or property damage.
Carefully check the traction drive and adjust
it properly, if necessary; refer to
the Operation of the Traction Drive (page 14)
for more information.
Important:
If the machine moves when the
traction lever is in the released position, check the
traction cable; refer to
the Traction Cable (page 24)
to an Authorized Service Dealer for service.
1. To engage the traction drive, squeeze the left
(traction) lever to the handgrip
Figure 20
2. To stop the traction drive, release the traction
lever.
10 Checking
Checking and Adjusting
or take the machine
(Figure 20).
Operating the Speed
Selector
The speed selector has 6 forward and 2 reverse
gears. To change speeds, release the traction lever
and shift the speed-selector lever to the desired
position (Figure
each speed selection.
Operating the
Auger/Impeller Drive
1. To engage the auger/impeller drive, move back
the lock switch on the lever, then squeeze the
right (auger/impeller) lever to the handgrip
(Figure 22).
g001011
2. To stop the auger and impeller, release the right
lever.
19
21). The lever locks in a notch at
Figure 21
Figure 22
g322971
g360687