Boutside Back Exhaust; Outside Back Exhaust; Oven Rear Panel; Back Exhaust - GE HVM1540SNSS Installation Instructions Manual

B

OUTSIDE BACK EXHAUST

INSTALLATION OVERVIEW
B1. Prepare Rear Wall
B2. Attach Exhaust Adaptor to
Wall Plate
B3. Attach Mounting Plate
to Wall
B4. Prepare Top Cabinet
B5. Adjust Blower
B6. Mount the Oven
PREPARING THE REAR WALL
B1.
FOR OUTSIDE BACK EXHAUST
You need to cut an opening in the rear wall for
outside exhaust.
1
Read the instructions on the REAR WALL
TEMPLATE.
2 Tape it to the rear wall, lining up with the holes
previously drilled for holes A and B in the wall
plate.
3 Cut the opening, following the instructions of the
REAR WALL TEMPLATE.
Installation Instructions
15
(Horizontal Duct)
ATTACH THE EXHAUST
B2.
ADAPTOR TO THE OVEN REAR
PANEL
1 Unscrew and remove the exhaust adaptor
assembly from the top of the oven.
Attach the exhaust adaptor to the oven rear
2
panel by sliding it into the guides at the top
center of the back of the oven.
Exhaust Adaptor
Guide
Push in securely until it is in the lower locking tabs.
Take care to assure the damper hinge is installed so
that it is at the top and that the damper swings freely.
Exhaust
Adaptor
Damper
(hinge side up)
Guide
Locking
Tabs