Table of Contents
Advertisement
Quick Links
Installation Instructions and Technical Documentation
Remote Monitoring System for
GSM-Messenger
Versions / Upgrades:
GSM-Messenger A3
- Third alarm input
GSM-Messenger A+
- Power blackout alarm
P. 1
GSM-Messenger
- Level indicators (1 - 4 indicators)
- Alarm/Error contact monitoring
- Consumption and event counter
- Operating hours counter function
Manual GSM-Messenger
Content
A Produkt of
TECSON GmbH & Co KG
Wulfsfelder Weg 2a
D-24242 Felde
Tel. (+49) 4340 - 402530
Fax (+49) 4340 - 402529
>>
www.tecson.de
Page:
2
2
2
2
4
6
7
7
7
8
8
8
<<
08-2019
Advertisement
Table of Contents
Related Manuals for Tecson GSM-Messenger
Summary of Contents for Tecson GSM-Messenger
- Page 1 DEVICE PARAMETERIZATION SMS REPORTS TECHNICAL DATA OPTIONS AND ACCESSORY LABELING GSM-Messenger A Produkt of TECSON GmbH & Co KG Versions / Upgrades: Wulfsfelder Weg 2a GSM-Messenger A3 D-24242 Felde - Third alarm input GSM-Messenger A+ Tel. (+49) 4340 - 402530...
- Page 2 The device operates with an integrated GSM mobile phone module that registers itself on the respec- tive mobile network. The LINK input can be connected to 1-4 TECSON oil level indicators. Additionally the device monitors the two event inputs A1 and A2 which are connected to a potential-free break or make contact (Relays / Reed).
- Page 3 Example of an input wiring: In the example above two level indicators are connected to the GSM-Messenger. The alarm input A1 is wired to the boiler failure signal contact. (Potential-free switching contact, possibly interpose a relay.) P. 3...
- Page 4 Before starting the installation, check the mobile networks signal strength per mobile phone. Normally the reception via the internal GSM-Messenger antenna will be sufficient. In case of a bad reception location (e.g. a deep basement) potentially mount and install the GSM- Messenger in a higher located room.
- Page 5 The adjusted parameters will remain unchanged. ’RESET+Clear’ : The GSM-Messenger software can also be reset into the original delivery status. Therefore press both buttons simultaneously and hold them for 5 sec. During this process all registers and parameters will be reset.
- Page 6 O ۞ O O 2 flashing impulses (cyclical) => SMS command is being received. O ۞ O O 3 flashing impulses (cyclical) => SMS report is being sent by the GSM-Messenger LED-3 ( RED ) Error code GSM or modem: ۞ GSM Error...
- Page 7 The parameters are sent as an SMS text from the mobile phone to the device. Likewise the device also reports to the parameterized phone numbers via SMS. See enclosed documentation “Messages, Commands and Parameters for GSM-Messenger”. The standard commands for status inquiry per mobile phone are #R or #M.
- Page 8 Tank inventory management system. 12095 Connection to the data base server Please inquire at TECSON. Labeling The manufacturer TECSON declares the compliance with the valid safety and test guidelines (CE Declaration). For Conformity Declaration refer to web-site www.tecson.de at menu item ‘Documentation’.
Need help?
Do you have a question about the GSM-Messenger and is the answer not in the manual?
Questions and answers