Electrical Connection - Elecro Engineering MINI H.R.UV-C STANDARD Installation & Operating Manual

All factory unions are made from ABS plastic, when gluing connections to an ABS pipe an ABS cement
must be used or when using a PVC pipe, a Transition cement must be used (See Fig. 7).
There is no need to use mastic or PTFE tape to connect unions to the device, use the O-rings provided to
put in the groove on the end of the Manifold Assembly.
NOTE: Be sure to apply the glue evenly and to all surfaces that will be in contact to reduce the
risk of leakage.

3.6 Electrical connection

• This device must be installed by a qualified Electrician following the
WARNINGS:
• Any alterations made to the unit (unless stated) will affect the warranty.
• Incorrect installation may result in serious damage to property/persons.
• The device must be installed in accordance with the country/regional
• The power supply must be fitted with a 30mA RCD.
• Never look directly at an illuminated UV lamp.
• This device must be installed by a qualified Electrician following the
WARNINGS:
• Any alterations made to the unit (unless stated) will affect the warranty.
• Incorrect installation may result in serious damage to property/persons.
• The device must be installed in accordance with the country/regional
• The power supply must be fitted with a 30mA RCD.
• Never look directly at an illuminated UV lamp.
instructions provided in this manual. The manufacturer will not be liable
for any issues caused by poor or improper installation.
This also applies if components are changed for non-standard
components acquired anywhere other than direct from the manufacturer.
requirements and regulations and an Electrical Installation Certificate
must be provided on completion of the installation.
instructions provided in this manual. The manufacturer will not be liable
for any issues caused by poor or improper installation.
This also applies if components are changed for non-standard
components acquired anywhere other than direct from the manufacturer.
requirements and regulations and an Electrical Installation Certificate
must be provided on completion of the installation.
8
Fig. 7