How To Set The User Modes - Canon imageFORMULA DR-7090C Reference Manual

10: 10 Mbyte/sec (First SCSI)
5: 5 Mbyte/sec (non-synchronous)
If the scanner does not operate correctly when the output
speed is set to '20' Mbyte/sec, reduce the transfer speed to
'10' Mbyte/sec or '5' Mbyte/sec.
■ Setting USB Short Packet
U S B S h o r t P a c k e t
[ O N ] O F F
Change the USB short packet settings. (default: ON)
If the scanner does not operate normally with your
computer's standard USB interface, change the short
packet setting to 'OFF'.
IMPORTANT
If you change the setting for the SCSI transfer speed or the USB
short packet settings, turn OFF the scanner, and then turn it ON.
■ Setting Single-Pass Duplex
S i n g l e - P a s s
[ O N ] O F F
Select the duplex (two side) scanning method used for
documents placed in the feeder tray.
ON: Scans both sides of the document page
simultaneously (default).
OFF: The scanner scans the front side of the document
page and then automatically flips the page to scan the
reverse side.
■ Total Counter
T o t a l C o u n t e r
Displays the cumulative total number of document pages
fed by the scanner.
D u p .
0

How to Set the User Modes

Use the following procedure to configure user mode settings.
1.
Press Menu to display the user mode screens.
Use the Menu key to cycle through the user modes in the
sequence shown below.
C o u n t O n l y M o d e
O N [ O F F ]
L o n g D o c u m e n t
O N [ O F F ]
S t a n d - b y M o d e
2 4 0 6 0 [ 1 0 ]
J a p a n e s e
O N [ O F F ]
D i s p l a y C o n t r a s t
2.
Use the and keys to change the currently
displayed setting.
3.
Press Enter to register the displayed setting.
4.
To exit the user mode screens, press Stop.
T o t a l C o u n t e r
0
S i n g l e - P a s s D u p .
[ O N ] O F F
U S B S h o r t P a c k e t
[ O N ] O F F
S C S I S p e e d
[ 2 0 ] 1 0 5
39
2