Table of Contents
Advertisement
Quick Links
Owner's Instruction and Operation Manual
Model Number:
GW1949
Report Number: F20-572
Certified to 1482-11 (R2015) and
Certified to ULC-S627-00-REV1
Mobile home approved
* All Pictures In This Manual Are For Illustrative Purposes Only. Actual Product May Vary.
Save These Instructions In A Safe Place For Future Reference.
SAFETY NOTICE: If this heater is not properly installed, a house fire may result. For
your safety, follow the installation instructions. Never use make-shift compromises
during the installation of this heater. Contact local building or fire officials about
permits, restrictions and installation requirements in your area. NEVER OPERATE
THIS PRODUCT WHILE UNATTENDED.
CAUTION! Please read this entire manual before you install or use your new room
heater. Failure to follow instructions may result in property damage, bodily injury, or
even death. Improper Installation Will Void Your Warranty!
U.S. Environmental Protection Agency
Certified to comply with 2020 particulate emissions
standards.
Do not install in a sleeping room
This unit is not intended to be used as a primary source of heat.
THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE.
© 2021 United States Stove Company, 227 Industrial Park Rd., South Pittsburg, TN 37380
R
CALIFORNIA PROPOSITION 65 WARNING:
This product can expose you to chemicals including carbon
monoxide, which is known to the State of California to cause
cancer, birth defects, and/or other reproductive harm. For
more information, go to www.P65warnings.ca.gov
852489J-0204K
Ph. 800-750-2723
Advertisement
Table of Contents
Related Manuals for United States Stove GW1949
Summary of Contents for United States Stove GW1949
- Page 1 This unit is not intended to be used as a primary source of heat. THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE. © 2021 United States Stove Company, 227 Industrial Park Rd., South Pittsburg, TN 37380 Ph. 800-750-2723...
- Page 2 INTRODUCTION This manual describes the installation and operation of the USSC, GW1949 wood heater. This heater meets the 2020 U.S. Environmental Protection Agency's crib wood emission limits for wood heaters sold after May 15, 2020. Under specific test conditions this heater has been shown to deliver heat at rates ranging from 9,762 to 38,544 Btu/hr and 0.94 g/hr and 69% efficiency.
-
Page 3: Installation Checklist
Declaration of Completion: As the qualified person responsible for the work described above, I confirm that the appliance as associated work has been installed as per manufacturer’s instructions and following any applicable building and installation codes. Signed: ______________________________________ Print Name: __________________________________Date: ______________ Home Owner: RETAIN THIS INFORMATION FOR FUTURE REFERENCE © 2021 United States Stove Company... -
Page 4: Main Body Assembly
Insert the damper slide into place; it will only fit one stove, the long end must face the right side of the way. stove. Damper Slide PELLET SLIDE INSTALLATION Install the pellet slide as shown. The chute (flat end) will © 2021 United States Stove Company... - Page 5 BURN TUBE & ASH TRAY INSTALLATION 2. Screw on the damper slide handle by turning clockwise. Install primary burn tube, secondary burn plate, and ash tray. Primary Burn Tube Secondary Burn Tube Damper Slide Handle Tray © 2021 United States Stove Company...
-
Page 6: Installation
787 mm • ALWAYS ALLOW STOVE COOL USA 48” 1.22m Width COMPLETELY BEFORE PERFORMING CAN 50” 1.3m MAINTENANCE. 16” 407 mm Right Side 18” 458 mm Left Side 8” 203 mm Front 8” 203 mm © 2021 United States Stove Company... -
Page 7: Clearance To Combustibles
You may contact your local building authority or person • Your stove does not draw steadily, smoke rollout occurs, having jurisdiction on height restrictions. wood burns poorly, or back-drafts occur whether or not there is combustion present. © 2021 United States Stove Company... -
Page 8: Importance Of Proper Draft
(Mobile Home) a fresh air opening of at least 2” (150 using hardwood pellet fuel. Long horizontal chimney runs mm) diameter into the room where the unit is installed will impede the draft and cause poor performance of this is required. stove. © 2021 United States Stove Company... -
Page 9: Combustible Wall Chimney Connector Pass-Throughs
The clay liner shall run from the brick masonry outer surface to the inner surface of the chimney flue liner but not past the inner surface. Firmly grout or cement the clay liner in place to the chimney flue liner. © 2021 United States Stove Company... - Page 10 24-gauge minimum sheet metal support. Maintain the space, or a floor, or ceiling. 6” (153 mm) space. There should also be a support sized © 2021 United States Stove Company...
- Page 11 PORTS – THIS WILL SERIOUSLY AFFECT THE THIS APPLIANCE IS DESIGNED FOR THE USE OF PERFORMANCE OF THE STOVE. PELLETIZED FUEL THAT MEET OR EXCEED THE STANDARD SET BY THE PELLET FUEL INSTITUTE (PFI). © 2021 United States Stove Company...
- Page 12 3. Let heat gun run for 30 seconds. PROPER USE OF OUTSIDE AIR. 4. Open the pellet feed door. 5. Ignition of the pellets will take approximately one minute. You will hear a “whoosh” when the pellets ignite. © 2021 United States Stove Company...
-
Page 13: Controlling The Temperature
Closing the damper just over the 5/16” mark on a tape measure. Only make will increase higher temperatures and heat output. small adjustments at a time as you will discover a small © 2021 United States Stove Company... -
Page 14: Helpful Hints
• Remedies for those that experience a temperature drop after several hours of operation: First, dump the ashtray and properly dispose of ashes as described in this manual. Second, clear the secondary burn plate © 2021 United States Stove Company... -
Page 15: Maintenance
ALWAYS EMPTY THE ASHTRAY AND CLEAR THE SECONDARY BURN PLATE PRIOR TO LEAVING THE STOVE UNATTENDED! © 2021 United States Stove Company... - Page 16 MATERIALS, PENDING FINAL DISPOSAL. a final cure that happens during the initial burn. This cure will last 20-30 minutes and will produce fumes and some smoke. © 2021 United States Stove Company...
-
Page 17: Spring Shutdown
Part numbers and descriptions can be found in the “Repair Parts” section of this manual. Once this information has been gathered you can contact customer service by phone 1-800-750-2723 Ext 5051 or Email parts@usstove.com. Model Information Model Number Serial Number © 2021 United States Stove Company... -
Page 18: Repair Parts
REPAIR PARTS © 2021 United States Stove Company... - Page 19 Call 1-800-750-2723 Ext 5051 or Email to: parts@usstove.com IN ORDER TO MAINTAIN WARRANTY, COMPONENTS MUST BE REPLACED USING ORIGINAL USSC PARTS PURCHASED THROUGH YOUR DEALER OR DIRECTLY FROM USSC. USE OF THIRD PARTY COMPONENTS WILL VOID THE WARRANTY. © 2021 United States Stove Company...
-
Page 20: Service Record
Engineer Name: ____________________________________ Engineer Name: ____________________________________ License No.: ________________________________________ License No.: ________________________________________ Company: __________________________________________ Company: __________________________________________ Telephone No.: _____________________________________ Telephone No.: _____________________________________ Stove Inspected: Chimney Swept: Stove Inspected: Chimney Swept: Items Replaced: ____________________________________ Items Replaced: ____________________________________ © 2021 United States Stove Company...