Safety Instructions; A) General; B) Before Operation - Reely SKY Extra 300 Operating Instructions Manual

The following components not included in delivery are required for the assembly and operation:
Assembly:
Soldering gun, balsa cutter, scissors, mini-drill with different bits, screwdriver, foil pen, 5-minute epoxy glue, if needed thixotropic agent (micro balloons or cotton
flocks) to thicken the glue, superglue, hinge strip or plastic hinges to attach the aileron and the vertical stabiliser, double-sided servo tape to attach the receiver,
two small wood strips and suitable glue clamps to install the vertical stabiliser
Caution!
Observe the safety notes of the respective manufacturer when using glues and work with glues in well-ventilated rooms only. When gluing balsa
wood with super glue, corrosive vapours which can be extremely harmful to your health are produced.
Operation:
To operate the model plane, you require a suitable remote control with at least 4 channels, 2 servos and a compatible receiver, and a drive set consisting of a
brushless motor, an airscrew, and a suitable flight battery.


6. Safety instructions

The guarantee/warranty will be void if damage is incurred resulting from non-compliance with the operating instructions. We assume no
liability for any consequential damage!
We do not assume any liability for damage to property or personal injury caused by improper use or the failure to observe the safety
instructions! In such cases the warranty/guarantee is voided.
Normal wear and tear and accident and crash damages (e.g. broken propeller or other broken parts) are also excluded from the guarantee and
warranty.
Dear Customer,
These safety instructions are not only for the protection of the product but also for your own safety and the safety of others. This is why you should
read this section very carefully before using the product!

a) General

Caution, important note!
Operating the model can lead to material and/or personal damage. Therefore, make sure that you are properly insured when using the model, e.g.
by taking out private liability insurance. If you already have insurance, enquire whether the operation of the model is covered before operating it.
Please note: In some EU countries you are required to have insurance for any flying models!
• The product is not a toy. It is not suitable for children under 14 years of age.
• The product must not become damp or wet.
• If you do not have sufficient knowledge as to how to deal with remote-controlled models, please seek the advice of an experienced model maker or a model
making club.
• Do not leave packaging material lying around unattended. It can become a dangerous toy for children.
• Should any questions arise that are not answered in the operating instructions, contact our technical support (see chapter 1 for contact information) or another
expert.

b) Before operation

• Unroll the aerial wire of the receiver in the model to its complete length. Parts protruding from the model must not be bent toward the front, attached to the
model or cut off. Reception is optimal when the aerial wire loosely protrudes from the model and is dragged along in flight.
• Make sure that no other models are operated on the same channel (transmitter frequency) within the range of the remote control. Otherwise, you will lose
control over the remote-controlled models! Always use different channels if you wish to operate two or several models in the immediate proximity of each other
simultaneously.
• Check the functional reliability of your model and of the remote control. Watch out for visible damage such as defective plug connections or damaged cables.
All moving parts of the model must run smoothly, but should not have any play in their bearings.
• Charge the flight battery necessary for operation as well as rechargeable batteries in the remote control according to the instructions provided by the
respective manufacturer.
20