Dell EMC SD-WAN Edge 3000 Series Activation Manual page 6

Figure 4. PPPoE configuration
6. Click Save (upper-right of the Configuration screen) to apply the settings.
7. When prompted, type in the default username admin and the default password admin and click OK.
NOTE: VMware activation retains the PPPoE address settings when the activation profile has the corresponding port
configured as a routed port.
Install and configure an SFP module as WAN interface
1. Verify that the SFP module you want to install is compatible with the device.
NOTE: For information about compatibility, contact your Dell Technologies Sales Representative.
2. Insert the SFP module in any SFP port.
Figure 5. SFP ports
NOTE: If the link lights do not illuminate, use the UI to reboot the SD-WAN Edge 3800 system.
3. When the module is ready, it shows as Available in the WAN interface with the associated DHCP address.
NOTE: Follow the procedure above to configure the static IP address if needed. If problems persist, see VMware KB article
KB59582.
Dell EMC SD-WAN Edge 3800 activation troubleshooting
Internet status not available
1. Verify physical cabling.
2. Ensure that the SD-WAN Edge 3800 MAC address is learned on the correct port or VLAN.
3. For static IP, verify that the IP address or mask and gateway are properly configured.
4. Verify that the VMware SD-WAN Gateway is reachable.
6