GE DCCH480EK Owner's Manual & Installation Instructions page 11

Water-Tank
Drain hole
Fixer Condenser
Emptying the Water Tank
1. Pull out the water tank.
CAUTION:
both hands as it is heavy and take care not to spill any water inside the tank.
2. Remove the condensed water inside the water-tank.
• Remove the condensed water in the tank after every drying cycle.
WARNING:
water after using the product, make sure to drain the water.
NOTE: When the Tank full indicator light is "on", the dryer will not operate until the tank is
emptied and the warning has been cleared. Press the START button and the indicator light
will turn off and the dryer will resume the cycle.
Cleaning the condenser
1. Open the condenser compartment cover.
2. Unlock the fixer condenser.
3. Remove the condenser.
4. Clean the condenser completely by allowing tap water to flow through it.
NOTES:
• Make sure to clean your condenser once per month to prevent degradation of the dryer's
performance.
• When assembling the condenser after cleaning it, make sure the fixer condenser is set to
the lock position.
When removing the Water tank from the product, hold it using
Since there is a chance of water leaking if you do not drain the
GEAppliances.com
11