Reliance Foundry Concrete Bollard Installation

Concrete Bollard Installation
Bollards shown in the diagrams may not be the same model as the bollards shipped in this order. This does not affect the integrity of the installation.
Parts List
# PART
1 Concrete Bollard
3 Fitted Rebar Template (supplied)
Installation Equipment
Auger
Dirt Tamper
Level
1
2
Chalk/Marker
Measuring Tape
Shovel
1-877-789-3245 | info@reliance-foundry.com | www.reliance-foundry.com
To protect the finish, keep bollards in packaging
until exact moment of installation.
Handle with care to avoid scratching or
damaging bollard surfaces.
Consider local soil conditions before
proceeding with bollard installation.
Before Installation
STEP 1: Study the site plans and mark the intended
location of each bollard on the plan.
STEP 2: Always check for hazards such as water pipes,
gas lines, and underground wiring before digging.
STEP 3: Please consult your local Building Code
Department to determine the recommended depth
below the frost line for digging in your area. Choose a
minimum of this or 12", whichever is greater. This is the
total digging depth. The diameter of the hole should
extend to a minimum of
drawing either...".
STEP 4: Center the auger on the installation mark and
bore a hole to the required depth and diameter.
QTY
1
1
New Concrete
??? (not mentioned in product
 ??
12"
FROST LINE