Installation - AEG MC1751E Operating Instructions Manual

Aeg microwave oven operating instructions
Hide thumbs Also See for MC1751E:
Table of Contents

Advertisement

Installation

INSTALLING THE APPLIANCE
1. Remove all packaging and check carefully for any
signs of damage.
2. This oven is designed to fit into a 360mm high
cupboard as standard.
When fitting into a 350mm high cupboard:-
Unscrew and remove the 4 feet from the bottom of
the oven. There are 3 tall feet and 1 short foot.
Replace the 3 tall feet with those provided in the
accessory pack. Do not replace the short foot.
3. If fitting the microwave oven above a conventional
oven (position A) then use the mylar sheet provided.
a. Cut the Mylar sheet to
fit the internal
width of the
unit.
b. Peel back the
protective
cover on the
tape and fix
to the rear of
the shelf so
that it covers
the service gap.
(See diagram).
SAFE USE OF THE APPLIANCE
If fitting the microwave in position B or C:
• The cupboard must be a minimum of
500mm (E) above the worktop & must not
be installed directly above a hob.
• This appliance has been tested and
approved for use near domestic gas,
electric and induction hobs only.
• Sufficient space between hob and
microwave should be allowed to prevent
overheating of microwave oven,
surrounding cupboard and accessories.
• Do not operate the hob without pans
when the microwave oven is operating.
• Care should be taken when attending to
the microwave oven while the hob is on.
Mylar sheet
Conventional
oven
Conventional
POSITION
Measurements in (mm)
4. Fit the appliance into the kitchen cupboard slowly,
and without force, until the front frame of the oven
seals against the front opening of the cupboard.
5. Ensure the appliance is
stable and not leaning.
Ensure that a 5mm gap is
kept between the cupboard
door above and the top of
the frame (see diagram).
6. Fix the oven in position with the
screws provided.
The fixing points are located on
the top and bottom corners of
the oven (see diagram, item 9,
on page 4).
7. It is important to ensure that the installation of this
product conforms to the instructions in this
operation manual and the hob or conventional oven
manufacturer's installation instructions.
Chimney
Position A
Position B
oven
NICHE SIZE
W
D
A
560 x 550 x 360
B + C
460 x 300 x 350
460 x 300 x 360
560 x 300 x 350
560 x 300 x 360
D
460 x 500 x 350
460 x 500 x 360
560 x 500 x 350
560 x 500 x 360
Position C
E
CHIMNEY
Gap Between
H
(min)
Cupboard & Ceiling
50
18
18
18
18
40
40
40
40
5 mm
Chimney
Position D
D
50
50
50
50
50
50
50
50
50
29

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mc1761e

Table of Contents