Advertisement
INSTALLATION
3. After you have insulated the join you can re-connect the power harness to the
camera.
NOTE: For cars with a computer controlled lightning system (CAN BUS) please
consult your owner's manual before installation.
NOTE: Make sure that you do not drill holes in the panels that have an opposite
face that is visible outside the car for example guard panels. In fact, whenever
drilling holes in the bodywork of a vehicle always check what is on the reverse side.
4. Connect one end of the supplied RCA video lead to the RCA lead coming from
the camera then run the RCA lead to the front under side of the driver side dash
board (This is were the mirrors loom will be located).
To do this you may need to remove the rear seat to pass the cable into the cabin
area. You may also need to remove the door scuff plates to run the wire along the
side of the vehicle. The RCA cable will then be hidden when you replace the scuff
plates.
When the cable is at the front of the vehicle the RCA cable needs to be run from the
scuff plate area to the under side of the dash behind the kick trim. (Remove the kick
trim if necessary to run cable).
5. Mount the Mirror Monitor to your rear view mirror by adjusting the quick connect
tabs. Connect the mirror monitor to the wiring loom and run the loom to the
underside of the driver's side dash hiding the cabling as you go.
4
Advertisement
