Sharp SJ-XP570PG Operation Manual page 30

Problem
The control panel does not work.
(Only for SJ-XP570PG,
SJ-XP620PG, SJ-XP660PG)
Some lines are on the surface of
the plastic parts.
Door alarm does not stop.
(Only for SJ-XP570EM,
SJ-XP620EM, SJ-XP660EM)
If you still require service
Refer to your nearest service agent approved by SHARP.
30
This may occur in one of the following cases.
• The panel or your finger is soiled with dripping, oil and etc.
• When you touch the panel with gloved hand, adhesive bandage on your
finger,nail or objects.
• Sticker or tape is affixed on the keys.
• Touch position is slightly off from the keys.
• Operate time is not enough for the keys to work.
• These are not defects during production.
The meeting part of the resin material or
the junction part of the metallic mold are
remained like lines.
If the door alarm does not stop after closing all doors, it is a defect. Contact
the SHARP service center for service.
Method of stopping the door alarm temporarily
Press "R" button and "F" button simultaneously
and continuously for 3 seconds or more.
• The door alarm will sound again after
approximately 2 days.
Solution
Line
Beep beep beep