Installing Backsplash Panels; Flat Backsplash Panels; Insulated Backsplash Panels - Accurex XBEW Installation, Operation And Maintenance Manual

Installing Backsplash Panels

Flat Backsplash Panel
Material: Stainless
31.25 INCH
CRITICAL
DIMENSION
NOTE
• Backsplash length up to 47.25 inches (1200.15 mm)
wide ship in one piece; panel lengths over
47.25 inches (1200.15 mm) ship in multiple pieces
HOLE DRILLED
when panel height is <66 inches (1674.4 mm) or
BY INSTALLER
>80 inches (2032 mm).
• Backsplash length up to 48 inches (1219.2 mm)
wide ship in one piece; panel lengths over 48 inches
1/4 INCH BOLT AND CAP NUT
(1219.2 mm) ship in multiple pieces when panel
SUPPLIED BY MANUFACTURER
height is ≥66 inches (1676.4 mm) or ≤80 inches
(2032 mm).
1. After hood is hung into position, slide the flat flange
of the backsplash panel behind the back of the
hood. If the hood is provided with flat backsplash
panels, divider bars will be provided. Install divider
bars between panels as shown in the flat backsplash
panel section view.
2. After the backsplash panel and dividers have been
HEMMED EDGE
positioned, drill holes in the panel and fasten to
the wall. (Fasteners provided by others). The holes
should be spaced to adequately secure the panel to
the wall.
WALL
3. Caulk the joints between the hood and the
backsplash panel with NSF Approved silicone caulk
(GE SCS1009 or its equivalent). Caulk provided by
others.
4. Caulk the joint between the backsplash panels when
multiple panels are required with NSF Approved
(GE SCS1009 or its equivalent). Caulk provided by
others.
LENGTH
WALL
HEIGHT
LENGTH
1 IN. (25.4 MM)
HEIGHT
Insulated Backsplash Panel
Material: Stainless
Insulation: 1 in. (25.4 mm)
WALL
LENGTH
NOTE
Panels up to 45 in. (1143 mm) wide ship in one piece;
FIG. 23
over 45 in. (1143 mm) in multiple pieces.
HOOD END PANEL
SLIDE FLANGE
BEHIND BACK
OF THE HOOD
Kitchen Hoods • Type I and Type II
1 IN. (25.4 MM)
HEIGHT
HOOD FRONT PANEL
BACKSPLASH PANEL
SECTION VIEW
OF BACKSPLASH
PANEL OVERLAP
11